Vacuum Cleaner Operation; Machine Adjustment Procedures; Adjusting Sanding Pressure - Kunzle & Tasin Bona Scorpion DCS Manual De Funcionamento

Starting the Machine (Cont.)
To sand, proceed as follows:
Keep the 'Start' button pressed
(A). Move the drum nearer the floor
gradually by slowly moving the drum
control lever forwards (B).
Suddenly releasing the lever may cause excessively deep furrows on the work surface which may be
difficult to remove with additional sanding.

Vacuum cleaner operation

Repeat the preceding steps until step 4, then proceed as follows:
5.
Disconnect the machine's
flexible hose from the outlet
on the trunk.

Machine Adjustment Procedures

Adjusting sanding pressure

To vary drum pressure on the floor using the pressure adjustment handle proceed as follows:
1.
To change from lower to higher pressure proceed by
lifting the handle (A) and turning it so that the pins are
placed in the other deeper section (B).
6.
Fit the flexible hose (provided
with vacuum kit) by inserting
one end (rigid plastic fitting)
into the outlet on the trunk
and
the other end (rubber fitting)
onto the edge sander
extraction pipe.
To stop the machine,
engage the drum lifting
lever (A) and release
the start button (B).
7.
Switch on the vacuum
cleaner by pressing the
switch on
the head.
2.
Move the handle to position (A) for less drum pressure
on the floor, or to position (B) for more drum pressure
on the floor.
Bona Scorpion DCS Manual
8.
Start up the connected tool Start up the connected tool
and commence use.
17
EN