Ac/Dc Voltage Measurements; Ac/Dc Current Measurements - Southwire 10020N Instrucciones De Operación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Symbols Used on LCD Display
V
Volts
A
Amps
AC
Alternating current
DC
Direct current
-
Minus sign
•)))
Continuity
Diode test
F
Farads (capacitance)
Hz
Hertz (frequency)
%
Percent (duty ratio)
Autoranging
Battery status
n
nano (10
µ
micro (10
m
milli (10
k
kilo (10
M
mega (10
-9
)
-6
)
-3
)
3
)
6
)
5
Operation

AC/DC Voltage Measurements

WARNING:
Observe all safety
precautions when working on live voltages.
1. Set the rotary function switch to the
V Hz% position.
2. Press the
button to select AC or DC
MODE
voltage.
3. Connect the test leads in parallel to the
circuit under test. For DC measurements
touch the red test probe to the positive side
of the circuit and the black test probe to the
negative side of the current.
4. Read the voltage on the LCD display

AC/DC Current Measurements

WARNINGS:
Observe all safety precautions when working on live voltages.
Do not measure current on circuits that exceed 500 V.
1. For current measurements up to 200mA AC/DC,
set the rotary function switch to the mA position.
2. For current measurements up to 4000µA AC/DC,
set the rotary function switch to the µA position.
3. Press the
button to select AC or DC current.
MODE
4. Remove power from the circuit under test,
then open up the circuit at the point where
you wish to measure current.
5. Touch the test probe tips in series with the
circuit being measured. For DC current,
touch the black test probe to the negative
side of the circuit and touch the red test
probe to the positive side of the circuit.
6. Apply power to the circuit.
7. Read the current on the LCD display.
NOTE: 0.2A/500V fast acting Resettable Fuse on mA and µA ranges.
No replacement required.
V
MODE
Hz%
®
MODE
Hz%
®
6

Publicidad

Tabla de contenido
loading

Tabla de contenido