Sun Blade 1000 Guía De Inicio página 45

Caution – Hold DIMMs only by their edges. Place DIMMs on an antistatic mat
whenever you set them down. Small amounts of static electricity can damage
DIMMs.
3. Install four DIMMs to the empty motherboard DIMM connectors as follows (see
):
FIGURE 9
a. Open both ejector levers outward on the empty DIMM connector.
b. Position the DIMM into the connector. Use the alignment notches on the
bottom edge of the DIMM to ensure correct orientation.
c. Press straight down on both DIMM top corners until the DIMM is fully seated
and both ejector levers on the connector close into the DIMM's side notches.
Caution – Verify that the DIMMs are fully and evenly seated. Failure to properly
seat the DIMM can cause electrical shorts that can damage the DIMM and/or the
system.
d. Continue installing DIMMs until you have filled the DIMM bank with four
identical DIMMs.
4. Continue with "Finishing the Installation" on page en-37.
en-29