Sun Blade 1000 Guía De Inicio página 52

7. Replace the peripheral assembly as follows:
a. Position the peripheral assembly into the chassis front.
b. Connect power and data cables to the rear cable connectors on all drives,
including the smart card reader.
c. Replace the four screws that secure the peripheral assembly to the chassis.
8. If necessary, remove any plastic filler panel from the front peripheral bezel
opening to which you are installing.
9. Replace the front peripheral bezel.
10. Continue with "Finishing the Installation" on page en-37.
FIGURE 13
en-36
Installing Additional Peripheral Drives