Sun Blade 1000 Guía De Inicio página 48

Caution – The torque-indicator driver that is shipped with your system has been
designed to have the precise torque value required for tightening the CPUs in this
system. Do not use a torque-indicator driver that was supplied with any other Sun
system, which might have a different torque value.
9. Use the torque-indicator driver provided to tighten the CPU module screws (the
driver is shipped in a green plastic holder in the hard drive bracket). Alternate
turning each screw evenly to tighten both sides until the gap on the tool closes
(see ).
FIGURE 10
10. Replace the torque-indicator driver to its green plastic holder, then replace the
holder to its storage location in the hard drive bracket.
11. Continue with "Finishing the Installation" on page en-37.
Installing an Additional CPU Module
FIGURE 10
en-32