Troy-Bilt TB2BV EC Manual Del Operador página 9

Installing the Vacuum Bag
1. Set the unit on a flat, level surface.
2. Align the bumps on the vacuum elbow tube with the slots on the
blower outlet (Fig. 8). The flared end of the vacuum elbow tube
should point to the right.
3. Insert the vacuum elbow tube into the blower outlet (Fig. 8).
4. Twist the vacuum elbow tube clockwise until it locks into place
(Fig. 8).
5. Insert the flared end of the vacuum elbow tube approximately 4
inches (10 cm) into the vacuum bag (Fig. 9).
6. Pull the cinch strap to tighten the vacuum bag around the
vacuum elbow tube (Fig. 9).
NOTE: The cinch strap should be tight enough to prevent the
vacuum elbow tube from slipping out of the vacuum bag, but
loose enough for the vacuum bag to have limited movement
along the vacuum elbow tube.
Upper
Vacuum Tube
Blower Outlet
Vacuum
Elbow Tube
Vacuum
Elbow Tube
Cinch Buckle
9
Dots
Arrows
Vacuum Tube
Fig. 7
Fig. 8
Cinch Strap
4 inches
(10 cm)
Fig. 9
Lower
Slots
Bumps
Vacuum Bag