Cleaning And Maintenance; Troubleshooting - Imetec E1201 Instrucciones Para El Uso

Ocultar thumbs Ver también para E1201:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 21
EN
Pour the solid and liquid ingredients in to the blender jug (2) without exceeding the 800
ml level on the jug.
Close the lid (1).
Insert the plug (9) in the socket.
Start the blender by setting the on/off control (7) to the
desired position.
If necessary, pour more liquid through the hole in the lid (1).
Stop the appliance by setting the on/off control (7) to the "0" position.
Disconnect the plug (9) from the socket.
Remove the lid (1) from the blender jug (2).
Lift the blender jug (2) from the motor unit (6).
Pour the mixture into a glass.
Clean the appliance after having used it.
Wash the removable components: the blender jug (2), the lid (1), the gasket (4) and
the ring nut (5) by hand with soap and water or in the dishwasher at a temperature no
higher than 55°C.
Clean the motor body (6) with a damp, well-wrung sponge.
Dry with a dry cloth.
Should one of the problems indicated occur, adopt the proposed solution:
Problem
The ice has not been crushed
properly
There are lumps in the pesto
12

CLEANING AND MAINTENANCE

TROUBLESHOOTING

Always crush ice in pulse mode with plenty of liquid.
Should the ice remain on top of the blades, turn the
appliance off and use a spatula to mix the content
again.
Close the lid (1) and continue with pulse mode opera-
tion.
Increase the amount of basil and oil.
Grate the cheese with the electrical grater to add it to
the preparation at the end.
Solution

Publicidad

Tabla de contenido
loading

Tabla de contenido