Associating Wireless Daylight Sensors - Lutron GRAFIK Eye QS Guía De Instalación Rápida

Daylight Sensor Setup
Associating wireless daylight sensors and GRAFIK Eye
(for wireless enabled units only):
1. Make sure the wireless mode of the GRAFIK Eye
Main menu
unit is "Enabled".
Zone Setup
2. Enter programming mode.
Sensor Setup 3. Use the Master buttons to highlight "Sensor setup" and press
the OK button to accept.
4. Use the Master buttons to highlight "Add wireless sensors" and
Sensor Setup
press the OK button to accept.
5. Press and hold the "Link" button on the daylight sensor until the
Add wireless sensors
sensor starts flashing. The info screen on the GRAFIK Eye
control unit will display the sensor's serial number.
Daylight
6. Press the OK button on the GRAFIK Eye
screen will confirm that the sensor has been assigned.
Add wireless sensors
(To disassociate a wireless daylight sensor from the GRAFIK
Eye
Initiate association
sensor install guide to return the sensor to its "out-of-box"
of sensors
functionality. Doing so will remove its programming from the
GRAFIK Eye
7. Repeat the above steps for all desired sensors.
Daylight
8. Exit programming mode.
xxxx-xxxx
Associating wireless daylight sensors through
QS Sensor Modules (QSM):
Press OK to Save
1. Press and hold the Program button on the QSM for 3 seconds
to enter programming mode. There will be 1 audible beep
and the Status LED will begin flashing. The info screen on the
GRAFIK Eye
Saved
*Assigned*
programming mode.
2. Press and hold the "Link" button on the daylight sensor for 6
seconds. There will be 3 audible beeps from the QSM to verify
association.
3. Press and hold the Program button on the QSM for 3 seconds
to exit programming mode.
Note: The wireless signal has a range of 9 m through standard
®
QS control unit, Refer to the Radio Powr Savr
®
QS control unit.)
®
QS control unit will display that the QSM is in
®
construction or 18 m line of sight.
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye
QS Wireless control units
®
1 9 2 10 3 11 4 12 5 13
QS control
®
QS control unit. A
®
daylight
TM
QS with DALI Control Unit Quick Installation and Operation Guide 18
®
6 14 7 15 8 16
9-16
1-8
QS
®
Radio Powr Savr
Daylight Sensor
QS Sensor Module (QSM)
Master
buttons
OK
OK
button
Timeclock
(back) button
Link
TM
button
Program button