Zone Mode - Lutron GRAFIK Eye QS Guía De Instalación Rápida

Daylight Sensor Setup

Zone Mode

This step allows you to assign sensors to zones on the GRAFIK Eye
Each zone can be assigned to only one sensor, but sensors can be assigned to more
than one zone.
Selecting Sensors
Daylight Sensor
1. If not already done, associate daylight sensors and set to "Zone
Setup
Mode".
2. Use the Master buttons to highlight "Setup" and press the
Calibrate
OK button to accept. Available sensors will be displayed.
3. Use the Master buttons to scroll through the sensors until the
one you wish to assign or unassign is highlighted, and press the
OK button to select it.
Saved
Searching
4. Use the zone raise and lower buttons for the desired zones to
assign or unassign the sensor to those zones. The zone raise
button assigns the displayed sensor, and the zone lower button
unassigns it. Press the Timeclock (back) button to return to the
Sensor x/y
list of available sensors. Repeat for additional sensors.
xxxx-xxxx
Calibrating the Sensors
1. Put any wireless Radio Powr Savr
RF
with the desired zones into Calibrate Mode: Press and hold the
"Cal" button for 6 seconds until the sensor flashes.
Note: After 5 minutes, Calibrate Mode will timeout, and the
Sensor
2. Press the Timeclock (back) button to return to the Daylight
Set Zones
Sensor screen. Use the Master buttons to highlight "Calibrate"
and press the OK button to accept.
3. Use the Master buttons to select the desired zone and press the
OK button to accept.
4. Use the Master buttons to select the desired light level for the
zone, and press the OK button to accept. Repeat for all zone
levels you wish to calibrate.
5. Exit programming mode.
Note: If wireless sensors are not found, verify that they are
Daylight Sensor
Setup
3 seconds
Calibrate
®
1 9
sensor will return to normal mode.
associated correctly.
Sensor Name Adjust Light
More light
Zone 1
Less light
For additional information, see the complete installation and operation guide at www.lutron.com/qs
GRAFIK Eye
2 10 3 11 4 12 5 13 6 14
QS control unit.
®
daylight sensors associated
TM
Saved
Saved
QS with DALI Control Unit Quick Installation and Operation Guide 19
®
7 15 8 16
9-16
1-8
OK
1 9 2 10 3 11
1 9 2 10 3 11
Radio Powr Savr
Daylight Sensor
Master
buttons
OK
button
Timeclock
(back) button
4 12 5 13 6 14 7 15 8 16
4 12 5 13 6 14
Zone raise: Press to
assign the displayed
sensor
Zone lower: Press to
unassign the desired
sensor
Cal.
TM
button