Information For Users - MBM GPL477G Instrucciones Para El Funcionamiento

1.

INFORMATION FOR USERS

Foreword
Original instructions. This document has been drawn up in the mother language of the manufacturer (Italian). The
information it contains is for the sole use of the operator authorised to use the appliance in question.
Operators must be trained concerning all aspects regarding functioning and safety. Special safety prescriptions
(Obligations-Prohibitions-Dangers) are carried in a specific chapter concerning these issues. This document cannot
be handed over to third parties to take vision of it without written consent by the manufacturer. The text cannot be
used in other publications without the written consent of the manufacturer. The use of: Figures/Images/Drawings/
Layouts inside the document, is purely indicative and can undergo variations. The manufacturer reserves the right
to modify it, without being obliged to communicate his acts.
These instructions are valid only if the country/nation code appears on the appliance. If the code doesn't appear
on the appliance, it's necessary to refer to the instruction manual to adapt the appliance to the conditions in use
in that country/nation.
Purpose of the document
Every type of interaction between the operator and the appliance during its entire life cycle has been carefully
assessed both during designing and while drawing up this document. We therefore hope that this documentation
can help to maintain the characteristic efficiency of the appliance. By strictly keeping to the indications it contains,
the risk of injuries while working and/or of economical damage is limited to a minimum.
How to read the document
The document is divided into chapters which gather by topics all the information required to use the appliance in a
risk-free way. Each chapter is divided into paragraphs; each paragraph can have titled clarifications with subtitles
and descriptions.
Keeping the document
This document is an integral part of the initial supply. It must therefore be kept and used appropriately during the
entire operational life of the appliance.
Addressees
This document is structured for the exclusive use of the "Generic" operator (Operator with limited responsibilities
and tasks). Person authorised and employed to operate the appliance with guards active and capable of performing
routine maintenance (cleaning the appliance).
Operator training program
Upon specific demand by the user, a training course can be held for operators in charge of using the appliance,
following the modalities provided in the order confirmation.
Depending on the demand, preparation courses can be held at the site of manufacturer or of the user, for:
• Homogeneous operator in charge of electric/electronic maintenance (Specialised technician).
• Homogeneous operator in charge of mechanical maintenance (Specialised technician).
• Generic operator for simple operations (Operator - Final user).
Pre-arrangements depending on customer
Unless different contractual agreements were made, the following normally depend on the customer:
• setting up the rooms (including masonry work, foundations or channelling that could be requested);
• smooth, slip-proof, perfectly level floor;
• pre-arrangement of installation place and installation of equipment respecting the dimensions indicated in the
layout (foundation plan);
• pre-arrangement of auxiliary services adequate for requirements of the system (electrical mains, waterworks,
gas network, drainage system);
• pre-arrangement of electrical system in compliance with regulatory provisions in force in the place of installation;
• sufficient lighting, in compliance with standards in force in the place of installation;
• safety devices upstream and downstream the energy supply line (residual current devices, equipotential earthing
systems, safety valves, etc.) foreseen by legislation in force in the country of installation;
• earthing system in compliance with standards in force;
• pre-arrangement of a water softening system, if needed (see technical details).
Contents of the supply
• Appliance
• Lid/s
• Metallic rack/s
• Rack support grid
• Pipes and/or wires for connections to energy sources (only when indicated in work order).
The supply may vary depending on the order.
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
- 3 - 3