OPERATION TECHNICAL MANUAL - MILL 5D - 10D
5.2- Para usar o JF 5D - 10D como forrageira
a) Loosen latch (1) and raise the cover (2).
2
b) Remove the countercover (3).
c) Install lower sealing (12) under mill rotor, according
1
picture below.
IMPORTANT: Maintain bent plate (3) out, leaving upper
outlet open.
3
d) Close cover (2), rising and tighten latch (1).
e) Adjust the height and distance of the forage jet.
f) To do it, loosen the wing nut (4) and push the deflector
12
(5) upward on downward, according desired. Then,
retighten nuts (4).
As more raised is the deflector, more distant will be throw
the forage and vice versa.
4
5
19