6. OPERATING CAUTIONS
1. Connect this product to an appropriate voltage outlet for your model. Do not use
with power strips or extension cords.
2. Do not run this product unattended.
3. Never operate if this unit has a damaged cord or plug, if it has been dropped, or in any
way, into water, if it does not work properly. Return it to a service center for repair.
4. If any abnormality occurs, discontinue use immediately until the unit has been examined
and repaired.
5. Always unplug the product immediately after use.
6. Never allow the power supply cord to be pulled, jerked, strained, twisted or severely
bent, especially at the plug connections. Damage will occur at the high flex point of
entry into the appliance, causing it to rupture and short. Handle the cord carefully
for longer life.
7. Never block the air openings of the main unit or place it where the air openings
may be obstructed.
7. OPERATING THE COMPRESSOR NEBULIZER
1. Take the power cord and plug into an electrical outlet. (Figure 7)
2. Locate the power switch on the front of the unit, and switch it to the "on" position as
shown below.
3. Check for moisture leakage near the connections.
10