Setting Up The Nebulizer Compressor And Nebulizer Accessories - Roscoe Medical Sierra Neb 2 Manual Del Usuario

5. SETTING UP THE NEBULIZER COMPRESSOR AND
NEBULIZER ACCESSORIES
1. Wash hands with soap and warm water and dry completely with a clean towel.
2. Place the compressor on a clean dust-free, stable and flat surface. Check the filter
monthly or every 10 – 12 treatments and replace if dirty, clogged, or wet to ensure
proper operation .
Note: Tubing and accessories are NOT sterile from package.
3. Make sure tubing and accessories have been cleaned and/or disinfected before first
use and after last daily treatment. Refer to the Cleaning and Disinfecting Tubing and
Accessories section on page 12.
4. Remove the nebulizer cap by twisting counter-clockwise until it stops and
lift up (Figure 3-1).
5. Fill nebulizer cup using eyedropper or syringe with prescribed medication. Do not fill
more than 8 ml per treatment (Figure 3-2).
6. Close the nebulizer cap and turn clockwise until it is tightened (Figure 3-3).
Figure 3-1 Figure 3-2
7
Figure 3-3