Adjustment Procedures; Routine Maintenance - American Sanders EZ-E Manual Del Operador

EN
Leveling
This machine can be leveled without tools. Grasp the adjusting screw,
"A", and loosen the lock nut, "B". (Figure 7).
Condition - Pad creates ridges on both edges or a "hop" is experi-
enced: Rotate both adjusting screws equal amounts clockwise. Tighten
locknuts and test on a piece of plywood. Repeat procedure until condi-
tion is corrected. We recommend you not exceed 1/8" rotation for each
attempt.
Condition - Pad creates a ridge on the tip of the pad: Rotate both
adjusting screws counter clockwise, tighten locknuts and test. Repeat
procedure until condition is corrected. Use only 1/8 rotation for each
A
attempt.
Condition - Pad creates a ridge on only one side of the pad: Either
rotate the adjusting screw of the side effected clockwise or rotate the
adjusting screw opposite counterclockwise, depending on whether the
ridge terminates beyond the tip of the pad or prior to it. If it is prior to
the tip, adjust the side effected, otherwise adjust the opposite side.
NOTE: If switching heads on the machine, it will need to be re-leveled.
CAUTION:
Failure to perform maintenance at recommended intervals may void warranty.
Carbon Brushes
Have the carbon brushes replaced at least every 500 hours and more frequently under heavy use.
Dust Bag
Periodically the dust bag should be turned inside out, shaken vigorously and machine washed in cold water
to prevent pore blockage and loss of dust control.
Bearings
To insure reliable performance, have armature and pad driver bearings inspected for wear or damage after every 1500 hours. If used heavily, have
the bearings replaced seasonally.
Belt
The belt should be inspected every 500 hours. Replace if there are cracks or signs of wear.
CAUTION:
Maintenance and repairs performed by unauthorized personnel could result in damage or injury. Maintenance and repairs
performed by unauthorized personnel will void your warranty. Failure to perform maintenance at recommended intervals may void warranty.

Adjustment Procedures

Routine Maintenance

10
A
B
Figure 7