Preparation; Initial Set-Up; Location; Gasoline Engine - Senco PC2017 Instrucciones De Operación

initial set-uP:

. Read safety warnings before setting-up air compressor.
2. Ensure the oil level is above the minimum notch and below the maximum notch on the dipstick. If low, add
Senco part number PC0344 compressor pump oil.
®

location:

in order to avoid damaging the air compressor, do not incline the air compressor transversely
or longitudinally more than 10°.
. Place air compressor at least 2 inches away from obstacles that may prevent proper ventilation. Do not place
air compressor in an area:
-where there is evidence of oil or gas leaks.
-where flammable gas vapors or materials may be present.
serious injury or death may occur if electrical sparks from motor and pressure switch come in
contact with flammable vapors, combustible dust, gases or other combustible materials.
When using the air compressor for spray painting, place the air compressor as far away
from the work area as possible, using extra air hoses instead of extension cords.
-where air temperatures fall below 32°F or exceed 04°F.
-where extremely dirty air or water could be drawn into the air compressor.

gasoline engine:

Do not place unit in an area where flammable gas vapors may be present. A spark could
cause an explosion or fire.
do not smoke while fueling!
Do not fill fuel tank while compressor is running or hot. Allow air compressor and engine
to cool down for two minutes before refueling.
Do not fill fuel tank to point of overflowing. Allow approximately 1/4" of head space for fuel
expansion.
always store fuel away from the air compressor while it is running or hot.
do not operate in an enclosed area. use this product only in well ventilated areas! the
exhaust from the engine contains carbon monoxide, a poisonous, odorless and invisible
gas. breathing the gas can cause serious injury, illness and possible death.
. Review "Risk of Fire or Explosion" pg. 4 before fueling.
2. Read the engine manual accompanying this air compressor for correct engine start-up maintenance
procedures.
3. Read and understand the safety labels located on the air compressor.
4. A minimum of 86 octane fuel is recommended for use with this air compressor. Do not mix oil with
gasoline.
5. Use of clean, fresh, lead free gasoline is recommended. Leaded gasoline may be used if lead free is not
available. Do not use gasoline containing methanol or alcohol.
6. Check the engine oil level before starting. (See engine manual.)
7. Fill the fuel tank according to the engine manual instruction.
8. Refer to the engine manual for all necessary maintenance and adjustments.
0

PreParation

cautiOn
Warning
Danger
Danger
Warning
Warning
Senco Gasoline Air Compressor Manual 2005
®