Rowenta ES-180 Instrucciones De Uso página 17

086080AL AN FR IT ES POR NE SU
•
Empty the tank and replace on the machine.
•
Pour 1/2 litre of pure spirit alcohol (do NOT use wine vinegar) into the tank.
•
Connect the machine and turn selector C1 to the "
•
The two start-up and water temperature lights will come on (fig. 13).
•
The cup selection lights will flash.
•
Select the weak espresso by turning the water dosage selector to the left (C4).
•
Press the 2-cups key "
•
Run a glass of alcohol vinegar through the system.
•
Disconnect the unit during operation while leaving selector C1 in the "
•
Wait 10 minutes, connect the unit and press the "2-cup" (C3) key once again until the alcohol vinegar has
dripped out completely.
B. Rinsing.
IMPORTANT !
• After descaling,rinse through 2-3 times with clear water (without coffee),as described in paragraph
"Before using for the first time".
• The appliance has now been descaled and is ready to be used once again.
9. GUARANTEE.
Your machine is guaranteed for one year, but any incorrect connection, handling or use other than described
herein will render the guarantee null and void.
The machine has been designed solely for domestic use, all other types of use rendering the guarantee null and vo i d .
Repairs arising from scaling shall not be covered under the guarantee.
If you have any after-sales or spares problems, consult your dealer or an approved service station.
10. PROBLEM SOLVING.
Problem
Filter-holder will not move.
Used coffee grounds are not dry
after the water has passed through.
Espresso flows too slowly.
18/09/02 16:39
" (C3).
Possible cause
You have forgotten to release the
filter-holder.
You have not tightened the filter-
holder correctly.
You have tightened the filter-
holder too much.
The ground coffee is too fine, too
oily or powdery.
The filter-holder is dirty.
The grid through which the water
passes is clogged.
Page 17
" position (espresso extraction) (fig. 5).
" position
Solutions
Lightly press the EJECT button
while turning the filter-holder to
the left (fig. 9).
Tighten the filter-holder more
securely.
Reduce the tightening torque.
Choose a slightly coarser g rind.
Clean the filter-holder according to
the instructions in para graph 7.B.
When the machine has cooled
down, clean the grid with a damp
sponge (fig. 17).