Transport Readiness / Device Positioning; Preparation For Inserting Tape; Inserting Tape In Tape Unrolling Device - Leister VARIANT T1 Manual Del Usuario

Transport Readiness / Device Positioning

• The material to be welded as well as welding nozzle (9) and pressure roller (11) must be clean.
• Hot air welding machine in transport readiness position
– Swivel guide roller (15) upwards.
– Push hot air blower (8) to the right until locking cam
(10) latches into the recess of holding handle (28).
Hot air blower (8) is in parked position.
– Lower transport rollers (26) by swiveling handle (27). This relieves
pressure roller (11) for transport.
– The transport rollers (26) are now functioning.
• Move hot air welding machine to welding position.

Preparation for inserting tape

Welding nozzle (9) must have cooled down (Chapter 1.8 Cooling, page 36).
• Hot air welding machine in transport readiness position (see above).
• To prevent swiveling out when starting the hot air welding machine, the control roller (14) must be aligned
parallel to the pressure roller (11).
• Lower the hot air welding machine into the welding position using handle (27). The transport rollers (26) have
no longer function and are thus relieved.
• Relieve tape tension lever (13).
14
Wrong

Inserting tape in tape unrolling device

• Insert a welding tape into tape holder (35) as follows:
A Loose screw lever (36)
Remove tape fixation (37)
B
Insert welding tape in a clockwise direction. Use bushing (40) if required.
C
Push tape fixation (37) onto tape holder (35) and tighten screw lever (36).
D
37
36
40
14
11
Correct
A
11
B C
8
28
10
9
11
Transport readiness
27
26
D
15
27
26
13
29