Leister VARIANT T1 Manual Del Usuario página 27

Info Icons
The following icons are shown on the display for information.
Welding nozzle cooling
down
Indicates that the temperature is rising
Indicates that the temperature is falling
Active Icons
The following icons are shown on the display and activated by pressing the e-Drive
Switch on heating and blower
(if blower not yet running)
Stop the drive
Start the drive
Automatic cooling down
(heating off, blower on)
Up in the structure
(back to the previous program)
Enter, confirm
Info Icons
Profile
Profile Profile
Profile
Profile
Profile
Save
Save Save
Save
Save
Save
Active Icons
Quick Info
How do I start the hot air welding machine VARIANT T1?
1. Establish mains connection to the electrical mains
Reset
Reset Reset
Reset
2. Main switch (3) ON
Reset
Reset
3. Press Drive button
4. Press Heating button
5. Press Blower button
6. Press e-Drive Heating up time approx. 1–2 minutes
7. Carry out a test weld according to the welding instructions of the
material manufacturer and national standards or directives.
Check test weld.
8. Welding
How do I switch off the hot air welding machine VARIANT T1?
1. Press e-Drive (Fig. 1).
2. Press «Cool down OK» e-Drive
Blower switches off automatically.
3. After welding nozzle (9) has cooled down, main switch (3) OFF
Device in Standby mode,
device is switched off
after a time
6.0
ON
6.0
6.0
620
620
620
100
100
and allow to cool approx. 4 minutes (Fig. 2).
Profile
Profile
Profile
Profile
Profile
Profile Save
Save
Save
Save
Save
Save
Reset
Reset
Reset
Reset
Reset
Reset
Turn e-Drive
Turn e-Drive
Turn e-Drive
%
%
OFF
Contact authorised
service centre
Progress bar
.
Select profile
Save changed name
Change profile name
To next screen
To previous screen
Reset daily distance to zero
6.0
6.0
620
80
80
%
Profile
6.0
80
(Fig. 1)
520
%
Profile
520
%
Profile
040
(Fig. 2)
27