Service And Repairs - Leister VARIANT T1 Manual Del Usuario

Leister VARIANT T1 / Tape Versions
Article no. 148.963 VARIANT T1, Tape width 25 mm, 230V / 3680W
Article no. 148.964 VARIANT T1, Tape width 50mm, 230 V / 3680 W
Article no. 148.965 VARIANT T1, Tape width 25 mm, 400 V / 5700 W
Article no. 148.966 VARIANT T1, Tape width 50 mm, 400 V / 5700 W
Accessories
Only Leister accessories should be used
Article no. 148.961 Kit for tape width 25 mm
Article no. 148.962 Kit for tape width 50 mm
Training
• Leister Technologies AG and its authorised service points offer free welding courses and training events.
Information at www.leister.com.
Maintenance
• The air inlet on the hot air blower (8) must be cleaned with a brush if soiled.
• Clean welding nozzle (9) with brass brush.
• Check power supply cord (1) and plug for electrical and mechanical damage.

Service and Repairs

• If the drive counter reaches 400 h or the blower counter reaches 2000 h, the message «Maintenance
servicing» will appear on the display (5) the next time the main switch (3) is switched on.
This message is displayed for 10 seconds and cannot be skipped by the controls (4).
• Repairs should only be carried out by authorised Leister service centres.
These guarantee a professional, reliable repair service within 24 hours, using original
replacement parts according to the circuit diagrams and replacement part lists.
Warranty
• For this tool, the guarantee or warranty rights granted by the relevant distributor/seller shall apply. In case of gu-
arantee or warranty claims any manufacturing or workmanship defects will either be repaired or replaced by the
distributor at its discretion. Warranty or guarantee rights have to be verified by an invoice or a delivery document.
Heating elements shall be excluded from warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandatory provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and tear, overload or improper handling.
• Warranty or guarantee claims will be rejected for tools that have been altered or changed by the purchaser.
43