Vertilux VTi Celtic 35 Serie Manual De Programación página 6

Setting or modifying the upper limit
CASE #1
Current limit
Desired upper limit
If the current upper limit is above the desired
limit, follow the procedure below, depending on
the position of the motor.
MOTOR ON THE LEFT
1. Rotate the hexdriver
the current upper limit.
DOWN
BUTTON
2. Press the down button
the desired upper limit and then press the
button to test the position of the new limit. Verify if
your current condition is the one described in
1 or 2 and perform the procedure again as needed
in each case until reaching the desired limit.
Take into consideration:
turn of the motor tube.
up button
Press the
the motor stops. Check the current position of
the upper limit, and follow either procedure,
depending on your case.
MOTOR ON THE RIGHT
clockwise "-" to modify
UP
BUTTON
until the shade is below
up
case
7 full turns of the hexagonal grey or yellow limit setting screws equals to 1
© 2018. Vertilux, Ltd. All Rights Reserved. Last revised: October 2018.
UP
BUTTON
on the remote control until
If the current upper limit is below the desired
limit, follow the procedure below, depending on
the position of the motor.
MOTOR ON THE LEFT
1. Rotate the hexdriver
modify the current upper limit.
DOWN
BUTTON
2. Press the down button
the desired upper limit and then press the
button to test the position of the new limit. Verify if
your current condition is the one described in
1 or 2 and perform the procedure again as needed
in each case until reaching the desired limit.
CASE #2
Desired upper limit
Current limit
MOTOR ON THE RIGHT
counter-clockwise "+"
UP
BUTTON
until the shade is below
up
vertilux.com
to
case
5