Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Deleting a single motor or channel
This is a convenient feature when there has been a programming mistake and it is required to
delete the programming from a single channel. Also, if you want to delete a programmed motor in
a single channel, turn off the power supply of all motors previously programmed in this channel
except the one you want to delete and follow this procedure.
1.
Select the desired channel using the
channel selector
button, and press and hold the
stop button
for about
2.
Press and hold the
2 s
until the motor "jogs". The selected
about
channel has been deleted. Motors previously
linked to this channel are not linked anymore.
Unlinking the motor from the remote control
Disconnect all the motors from the power supply except the one you want to delete on the
remote control.
1.
Press the stop button for approximately
until the motor "jogs".
2.
Press and hold the
about
7
s. The motor will "jog", and in a few
seconds the motor will
The motor is now unlinked from the remote
control.
vertilux.com
8
© 2018. Vertilux, Ltd. All Rights Reserved. Last revised: October 2018.
5 s
until the motor "jogs".
programming button
for
5 s
programming button
for
"jog"
two more times.
STOP
BUTTON
PROGRAMMING
BUTTON
STOP
BUTTON
PROGRAMMING
BUTTON
Publicidad
Tabla de contenido
Solución de problemas
