Bosch SHV99A13UC Manual Del Usuario página 18

Care and Maintenance
(continued)
ChecldClean the Filter System
This dishwasher has a filter system that consists
of a Large Object Trap/Cylinder Filter assembly
and a Fine Filter. Select models have an
additional Micro Filter. The filter system is located
on the inside of your dishwasher under the lower
rack and is easily accessible.
During normal use, the filter system is
self-cleaning. You should occasionally inspect it
for foreign objects and clean it when necessary.
To Remove the Large Object Trap/Cylinder
Filter Assembly:
1. Remove the bottom rack.
2. Grasp the assembly as shown in Figure 31
and turn it counterclockwise 1/4 turn.
Figure 31
To Remove the Fine Filter and the Micro
Filter:
1. Lift the Fine Filter from the dishwasher floor
as shown Figure 33
in Figure
33 and
flush it
clean by
holding it
under
running
water.
2. Remove the Micro Filter
as shown
in Figure 34
and flush
it clean
by holding
it under
running
water.
Figure 34
3. Lift out the assembly as shown in Figure 32.
Figure 32
Large
Object
-Trap/
Cylinder
Filter
could contain sharp objects. Do not reach
into the large object trap with your fingers,
4. Carefully examine the assembly. If you find
debris in the Large Object Trap, turn it
upside=down and gently tap it on a surface
such as a countertop to dislodge and
remove the debris. Flush the Cylinder Filter
clean by holding it under running water.
To reinstaml the filter system:
1. Return the Micro Filter (select models) to its
installed position.
2. Return the Fine Filter to its installed position.
3. Place the Large Object Trap/Cylinder Filter
Assembly into its installed position in the
dishwasher floor.
4. Turn the ring handle clockwise 1/4 turn until
it is locked. Figure 35
The arrow
on the ring
handle
and the
arrow on
the Fine
Filter
should
point to
each
other, as
shown by the circle in Figure 35.
5. Gently pull the ring handle to ensure that the
assembly is locked into place.
17