Tabla de contenido
Publicidad
Loading Parts
Teile einsetzen • Chargement des pièces •
Carga de piezas • Caricamento delle parti
1
Remove the Finisher shelf and place it on an absorbent drip pad.
2
Arrange unfinished VisiJet parts on the shelf, then place the shelf
with parts back on top of the Finisher tray.
3
Distribute parts evenly to enable airflow. Do not overfill the
chamber. Parts should occupy no more than two-thirds of the space
above the shelf.
Verify that parts do not overhang any tray edges before you start
the finishing cycle.
Load parts
T eile einsetzen
Charger les pièces
Cargue las piezas
Caricare le parti
Sätt in delarna
Isæt dele
Lataa osat
15
T
Publicidad
Tabla de contenido
