Tabla de contenido
Publicidad
Dip Finishing
Trocken-Fertigstellung • Finition par immersion • Acabado por inmersión • Finitura per immersione
Summary only – see the
Finishing Parts
Guide
for complete dip finishing instructions.
1
Perform
Finisher Start-Up
. (See p. 19.)
2
Place tray of solid wax or support material in Finisher and close the door.
3
Switch
HEATER
ON. (If the
turn ON, try resetting the heater. See
4
Heat tray at TEMP CONTROL setpoint until liquid is 70 °C to 75 °C (~5 hours
initially). Keep the liquid at 70 °C to 75 °C to save time next cycle.
5
Open door and dip unfinished parts in tray of hot liquid until support material is
removed.
6
Perform
Dry Finishing
(wrap and dry heat) step
support material.
section of your
InVision Finisher User's
OUT
LED on the
TEMP CONTROL
reset
instructions on p. 19.)
6
on p.
23
panel does not
Dip parts in tray
T eile in Schale tauchen
Immerger les pièces
dans le plateau.
Sumerja las piezas en
la bandeja
Immergere le parti
nel vassoio
Doppa delarna i brickan
Dyp delene i bakken
to remove residual
Upota osat astiaan
29
T
Publicidad
Tabla de contenido
