Tabla de contenido
Publicidad
Dry Finishing
Trocken-Fertigstellung • Finition à sec • Acabado en seco • Finitura a secco
Summary only – see the
Finishing Parts
User's Guide
for complete dry finishing instructions.
1
Perform
Finisher Start-Up
. (See p. 19.)
2
Place absorbent drip pad in empty Finisher tray.
3
Switch
HEATER
ON. (If the
not turn ON, try resetting the heater. See
4
When the chamber temperature is at the TEMP CONTROL setpoint,
parts
in the Finisher. (See p. 15.)
5
Heat parts at TEMP CONTROL setpoint until support material is removed.
Check parts periodically. Do not heat them longer than necessary.
6
Remove parts, wrap separately with paper wipes, then briefly reheat them
to remove residual support material.
section of your
InVision Finisher
OUT
LED on the
TEMP CONTROL
reset
instructions on p. 47.)
Place pad in tray
Unterlage in Schale einlegen
panel does
Placer la surface d'égouttement
sur le plateau.
Coloque la almohadilla en la
load
bandeja
Collocare il cuscinetto nel
vassoio
Placera underlaget i brickan
Anbring puden i bakken
Aseta alusta astiaan
23
T
Publicidad
Tabla de contenido
