Getting Started; Cleaning And Troubleshooting Your Waterpik; Water Flosser - Waterpik WP-360 Manual De Instrucciones

Assembling the Reservoir
Slide Water Flosser power handle into back of
reservoir and press firmly to snap into place.
Preparation and Use
Refer to the Quick Start Guide for proper use
instructions.
Adjusting the Pressure Setting
You can adjust the pressure setting on your Water Flosser by simply
changing tips.
When Finished
Turn the unit off. Empty any liquid left in the reservoir.
Using Mouthwash and Other Solutions
Your Waterpik Water Flosser can be used to deliver mouthwash and
®
antibacterial solutions. After using any special solution, rinse unit to
prevent clogging by partially filling reservoir with warm water and running
unit with tip pointed into sink until unit is empty.

CLEANING AND TROUBLESHOOTING YOUR WATERPIk

Cleaning
Never immerse unit in water. Before cleaning, unplug
from the electrical outlet. Clean the product when
necessary by using a soft cloth and mild non-abrasive
cleanser to wipe exterior.
The water reservoir is removable for easy cleaning
and is top rack dishwasher safe. It is recommended
that the reservoir is removed and cleaned weekly. To
remove, flip the flip top water inlet all the way back
and push it against the power handle, using the flip
top as a lever.
Removing Hard Water Deposits
Add 1 tablespoon of white vinegar to a full reservoir of warm water. Point
the handle and tip into sink. Turn unit ON and run until reservoir is empty.
Rinse by repeating with a full reservoir of clean warm water.
Battery Care and Disposal
The unit will NOT charge if the switch is in the ON position. If you use
your Water Flosser once a day or less, it is recommended you charge it
overnight, once a week. If you use it twice a day or more, charge the unit
more frequently. Do not run the batteries down completely as this may
7

GETTING STARTED/

®

WATER FLOSSER