Turbosaver TS-1400B Manual De Usuario página 18

11. Gasket:
Keep air away by forming vacuum chamber. Clean and dry or replace it when it is distor-
ted or broken.
12. Air Intake:
Air intake connects with vacuum chamber and pump. Do not cover this intake when
placing bag for vacuum &Seal operations.
13. Bag Fixer:
To hold the open end of a bag for the placement of the bag.
14. Vacuum Chamber:
Position the open end of the bag inside the chamber, draws air out of bag and catches
any liquid overflow from the bag.
15. Sealing element:
Teflon-coated heating element which is hot and seals the bag.
16. Bag Cutter:
Press and slide in one direction or another to cut bags to a desired size.
17. Cutter Rack:
Support the cutter to slide along
OPERATING INSTRUCTIONS
Making a Bag with Bag Roll
1.
Open the cover and make sure the bag cutter is on one end of the cutter rack, Then
put the cutter rack to the back.
2.
Pull out the bag to the suitable length you want, then put down the cutter rack and
make sure it is on the right place of the bags, then slide the cutter from one end to the
other end to cut the bag .
3.
Put one end of the bag on top of the sealing element, but not enter the vacuum cham-
ber.
4.
Close the cover and press handle to lock the cover.
5.
Press "Maunal Seal" button to start sealing the bags. The indicator light to indicate
sealing operate, progress LED will show the sealing progress.
6.
When the indicator turn off, the sealing is done, rise the handle to open the cover and
take the bag out of the machine. the bag is then done and is ready for vacuum sealing.
18