Briteq Beam Wizard 5x5 Manual De Instrucciones página 11

ENGLISH
[SET CONFIG > FIXTURE Set] –
This level contains some general settings.
[TILT Invert]
Used to select if the TILT movements are inverted or not.
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the values can be changed
 Use ▲/▼ buttons to toggle between ON and OFF.
 Press the [ENTER] button to confirm.
[PAN Invert]
Used to select if the PAN movements are inverted or not.
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the values can be changed
 Use ▲/▼ buttons to toggle between ON and OFF.
 Press the [ENTER] button to confirm.
[PAN Range]
Used to select the maximum range for the PAN movements.
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the values can be changed
 Use ▲/▼ buttons to select the desired PAN range:
 540°
PAN range = 540° (or 1 ½ rotations)
 630°
PAN range = 630° (or 1 ¾ rotations)
 Press the [ENTER] button to confirm.
[FEEDBACK]
This function corrects the PAN/TILT positions automatically if someone bumps into the machine.
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the values can be changed
 Use ▲/▼ buttons to toggle between ON and OFF.
 Press the [ENTER] button to confirm.
[STANDBY]
To save energy the projector goes in sleep mode after a certain time when no DMX is detected.
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the values can be changed
 Use ▲/▼ buttons to select one of these options:
 [OFF]
standby function not used
 [0xxM]
The time (from 001 to 099 minutes) before the standby function is activated.
 Press the [ENTER] button to confirm.
Remark: when during standby mode a DMX-signal is detected, the projector first performs a reset.
[FUNC. Delay]
On the Function channel (last channel of the DMX chart) you can select some special functions, like
"blackout during PAN/TILT" and others. With this option you can select the delay before a selected
function becomes active.
IMPORTANT INFORMATION: the function delay can only be set to zero seconds (no Delay) when you are
using a DMX-controller or DMX-software using presets for the DMX-values of the special functions.
Never use "no Delay" while using a simple DMX-controller with faders to set the functions manually!
 Press the ▲/▼/◄/► buttons until the desired function is showing on the display.
 Press the [ENTER] button: the values can be changed
 Use ▲/▼ buttons to select one of these options:
 [NO Delay]
 [1s Delay]
 [2s Delay]
 [3s Delay]
 Press the [ENTER] button to confirm.
BRITEQ
®
special function is immediately activated
special function is activated when the DMX-value is unchanged for 1s.
special function is activated when the DMX-value is unchanged for 2s.
special function is activated when the DMX-value is unchanged for 3s.
9/107
OPERATION MANUAL
BEAM WIZARD5x5-RGBW