Briteq Beam Wizard 5x5 Manual De Instrucciones página 17

ENGLISH
 Internally the selected DMX-universe is treated as a normal DMX-signal so further setup of the DMX-
address, channel mode etc. should be done as usual.
 Thanks to the internal Art-Net node all 512 channels of the selected DMX-universe are automatically
converted from Art-Net to the DMX-output: they can be used to control other DMX-equipment:
RDM FUNCTIONS / REMOTE SETUP
RDM means "Remote Device Management". This projector works with a brief set of RDM-functions which
means that it can setup a bi-directional communication with an RDM-compatible DMX-controller. Some of
these functions are briefly explained below, others will be added in the future.
 The DMX-controller sends out a "discovery command", all RDM devices respond and send their unique
device ID.
 The DMX-controller asks each RDM device for some basic data so it knows which devices are connected.
The projector will respond:
 Device name: BEAM WIZARD5x5
 Manufacturer: Briteq®
 Category: LED Dimmer
 Firmware: x.x.x.x
 DMX address: xxx
 DMX footprint: xx
 Personality: xx
 The DMX-controller can send certain commands to each RDM device which allow remote setup of the
units. Thanks to this the projector can be setup remotely.
The following functions can be managed remotely:
No more need to take a ladder and set all units one by one!
 DMX START ADDRESS: The start address can be set remotely from 001 to xxx.
 PERSONALITY: The DMX working mode (DMX-chart) can be set remotely.
These 2 functions make it possible to prepare a complete DMX-patch of all projectors on the DMX-
controller and send these data to all projectors at once. More functions will be added later.
BRITEQ
®
(firmware version of the projector)
(current DMX start address of the projector)
(number of DMX-channels used by the projector)
(current personality [or DMX-working mode] used by the projectors)
15/107
OPERATION MANUAL
BEAM WIZARD5x5-RGBW