Installing The Battery; Removing The Battery; Charging The Battery - Simplicity S65 Manual Del Usuario

Warning:
The S65 battery included
can only be used with the S65 model as
intended.

Installing the Battery

Push the battery into the battery
compartment until it clicks into place
(Fig. 1).

Removing the Battery

Press the two battery release buttons
and pull the battery pack out of the main
body (Fig. 1).

Charging the Battery

The battery is partially charged and will
run for a short time.
1. Set the main body onto the
Storage/Charging Station, ensuring
the connection between points
on body with Storage/Charging
Station (Fig. 2).
2. Plug the battery charger into the
Storage/Charging Station and into
an electrical outlet (Fig. 3). The
indicator light on the battery will
be red while the battery is charging.
When the indicator light is blue, the
battery is fully charged (Fig. 4).
Charging time is approximately
4-5 hours.
3. Remove the battery charger from the
vacuum and begin vacuuming.
Battery Indicator Light
Solid Blue = Fully Charged
Solid Red = Low Battery
ASSEMBLING THE VACUUM
Fig. 1
Fig. 2
Fig. 3
Fig. 4
5