Connecting Ptz Cameras - Appendix #5 - Lorex L15LD420 Serie Manual De Instrucciones

Connecting PTZ Cameras - Appendix #5

Connecting PTZ Cameras - Appendix #5
PTZ Cameras (not included with this system) can be connected to the PTZ Control Block on the
back panel of the System. The PTZ Controls are enabled through the Menu system on the
Observation System. Additional PTZ Cameras are available at http://www.lorexcctv.com
Installing a PTZ (RS-45 Type) PTZ Camera:
1. Connect the Transmit Cable to the D+ port on the PTZ Control Block on the Observation System.
2. Connect the Receive Cable to the D- port on the PTZ Control Block on the Observation System.
3. Connect the Camera to BNC Channel 1 (DIN Channel 1 must be empty).
Connection Setup
Note: Connect the D+/D- of speed dome camera to the D+/D- of DVR.
PTZ setup
Different baud rate setting may be required for different PTZ camera (speed dome camera).
Please refer to speed dome camera user's manual for proper baud rate setup.
[EXTERNAL DEVICE]
SYSTEM MENU -> EXTERNAL DEVICE -> PANTILTSETUP -> COMMAND SETUP
[MODEL]:
Select protocol.
[PTZ ID]:
Enter the device ID.
[BAUDRATE]:
Baudrate setup
[CMD DELAY]:
The delay time for next command. Please refer to the PTZ camera user's manual for the
suggested value.
50
PTZ CAMERA
(Not Included)