Reset Condition; Reset Delay - Brightwell Brightstar II Manual De Instrucciones

P
ROGRAMMING
The BrightStar Laundry unit, will allow the user to set the
condition under which the unit will reset.
This condition defaults to LAST PUMP, but has three
possibilities:
LAST PUMP
The unit will re-set after the last pump (usually the fabric
softener) has run.
FEATURE OFF
This feature would usually be used on tunnel machines, with
the PULSE COUNT set to "ALL". In this mode, the Formula
Select can be used to change the program at any time a pump
is not running.
INPUT 6 (or INPUT 10 of a 7-10 pump unit)
If fabric softener is not being used, the signal from the softener
solenoid can be taken to input 6.
The unit will then reset after it has received a signal to input 10
on the A & B rails, even though no softener is being dispensed.
Setting:
UP DOWN
Use the and
FWD/ACCEPT
condition. Use the
and move on to the RESET DELAY screen.
P
ROGRAMMING
The RESET DELAY, allows the user to set the time that the unit
will wait, before it resets, ready for the next wash.
UP DOWN
Use the and
FWD/ACCEPT
Use the
on to the SUMMARY screen.
B L S
RIGHTSTAR AUNDRY YSTEMS
-
R
ESET
keys to select the required reset
key to confirm your selection
-
R
ESET
keys to select the required delay time.
key to confirm your selection and move
C
ONDITION
SET RESET TO
SET RESET TO
SET RESET TO
SET RESET DELAY
D
ELAY
SET RESET DELAY
SET RESET DELAY
01 I/P1234567890
PUMP 1
PUMP 2
PUMP 3
32
LAST PUMP
FEATURE OFF
INPUT 10
00MIN 00SEC
00MIN 00SEC
00MIN 30SEC
E
NGLISH
SET RESET TO
INPUT 6
01 I/P123456
PUMP 1
PUMP 2
PUMP 3
B L S
RIGHTSTAR AUNDRY YSTEMS