Taking A Reading; Calibrating The Gauge - Elcometer 456 Serie Instrucciones De Uso

R

5 TAKING A READING

1 Hold the probe by its sleeve
2 To take a reading, bring the probe down onto the surface whilst holding it perpendicular
3 For subsequent readings, lift the probe off and then replace it onto the coated surface
ü
DO
Hold the probe by the probe sleeve
•
• Gently place the probe onto the surface
• Allow the sleeve to make contact with the
surface - to improve accuracy
4
The display will dim if inactive for more than 15 seconds and will go 'black' if inactive for the
period defined in Menu/Setup/Display/Screen Timeout.
4
The gauge will switch off automatically after 5 minutes of inactivity
4
- - -
indicates reading outside range of probe

6 CALIBRATING THE GAUGE

1 Press the Cal softkey
2 For alternative calibration methods, select Cal/Cal Method
3 Select Calibrate and follow the on-screen instructions
4 When prompted place the probe on the centre of the foil(s)
4
Foils can be stacked
4
Not all calibration methods are available for all gauge types
see 7 Calibration Methods
5
û
DO NOT
Drag the probe over the coated surface
•
• Bang the probe down hard onto the surface
• Allow the probe to hover over the surface as
this could result in a false reading
90°
www.elcometer.com