Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Auto Power Off
The meter has an auto power off
feature that will turn the meter off
automatically if left on. After approx.
14 minutes of non-use, the meter
will sound 5 short beeps and then 1
minute later the meter will sound 1
long beep and turn itself off.
After auto power off has occurred,
either move the rotary switch or
press FUNC, MAX or RAN buttons to
turn the meter back on.
If you hold down the HOLD button
when turning on the meter, this will
disable the auto power off function.
The auto power off function will re-
enable after the meter is turned off
again.
DC Voltage
1. Use the probe cover if making
measurements on category III or
above installations.
2. Insert the black test lead into the
COM jack.
3. Turn the rotary switch to the
position.
www.grupotemper.com
Pen type multimeter
Preparing for
measurement
Select the desired function using the
rotary switch. If in manual mode,
select the highest range first if the
value to be measured is unknown
beforehand and lower as needed.
When connecting the meter to a
circuit, connect the common lead
first then the meter's test probe.
lf the battery voltage becomes <2.4V,
the
symbol appears on the
display. Replace the batteries before
making measurements.
4. The default mode is DC voltage.
Press RAN to switch to manual
range if needed.
5. Connect the test probe and test
lead across the voltage source or
load for measurement.
6. The display will show the measured
value. Observe the polarity of
the test probe for DC voltage
measurements.
Instructions manual |
KM 8212
29
Publicidad
Capítulos
Tabla de contenido
