Adjustments; Height Adjustment - Craftsman 124.34986 Instrucciones De Uso

1. Table adjustment
A. Tilting adjustment:
- On underside of table support bracket, loosen the nut (right-handed rotation)
with an open end wrench and back out the threaded pin. Loosen large hex
See Fig.9
head bolt.
- Rotate table to desired angle right or left. Use bevel scale for precise setting.
See Fig.10
- Tighten hex head bolt to secure table tilt. Threaded pin should not come into
the hole when table is tilted.
- To return table to level, loosen large hex head bolt. Rotate table to level
position. Make nut and thread pin end at the same level position, then push
the thread pin into the hole. Securely tighten large hex head bolt.
B. Height adjustment
Loosen the clamp bolt then adjust the table to your desired position by
turning the table bracket crank handle. See Fig. 11
C. Swing Adjustment 360°
Loosen the table swing locking handle, then swing table to desired
position and retighten the handle. See Fig. 12
ADJUSTMENT
10
Figure 9
Figure 10
Crank
Clamp bolt
handle
Figure 11
Table Swing Locking
Handle
Figure 12