Activate/Deactivate Call Duration Display; Setting The Pause Time; Changing The Dialing Mode; Using Caller Id (Cid) - Gigaset 5040 Guia De Inicio Rapido

Activate/deactivate call duration display

The telephone can display the approximate call dura-
tion in the display (up to 99 min. 59 sec., default setting
is "on"). If the call duration display is activated, the time
display begins 8 seconds after the last digit is dialed.
º18#
Hold down the Set key, then press the keys
1, 8. Press the Pound key.
0 1
/ Press one of the keys below.
0 to deactivate, or 1 to activate.
º
Hold down the Set key.

Setting the pause time

If necessary, the pause time of the Pause key
(pause function from second input position) can be
changed to 1, 3 or 6 seconds (default setting is 3 sec-
onds).
º102
Hold down the Set key, then press the keys
1, 0, 2.
0 2
... Press one of the keys below.
0 is 1 sec, 1 is 3 sec, 2 is 6 sec.
º
Hold down the Set key.

Changing the dialing mode

You can choose between two dialing modes:
º#
Hold down the Set key, then press the
Pound key.
1 2
/
1: Tone dialing.
2: Pulse dialing without flash function.
º
Hold down the Set key.
The dialing mode is saved.
10
en
Changing dialing modes during a call
If your telephone is set to pulse dialing and you want to
use functions that require tone dialing (e.g. remote
access to an answering machine), you can change the
dialing mode during a call.
*
o
The telephone is reset to the original dialing mode by
hanging up the handset.
Setting the time for the Flash key
º195
;
0 4
...
º

Using Caller ID (CID)

Under the following conditions, the phone numbers of
incoming calls are
(a) shown on the display and
(b) automatically saved in a Calls list:
◆
Both your network provider and the caller's network
provider must offer CID.
◆
Both you and the caller must have requested this ser-
vice (if necessary) from your respective network pro-
viders.
If these conditions are met, but a caller has suppressed
CID before making the call, you will see
---P--- on the display instead of the phone number. If
the number could not be identified for other (technical)
reasons, you will see ---0--- or
---E--- on the display.
Up to 14 digits can be shown on the display. With longer
numbers the last 14 digits display.
With an open connection, press the Star
key.
Enter the digits for remote control.
Hold down the Set key, then press the keys
1, 9, 5.
Enter desired flash code:
0: 90 ms (default setting);
1: 120 ms; 2: 270 ms;
3: 375 ms; 4: 600 ms;
Hold down the Set key.