Bimar FFFRoid VR20 Manual De Instrucciones página 12

- main unit (19) 1 piece, tank (4) 1 piece, castors with brake (6) 2 pieces and
pivoting wheels (7) 2 pieces, remote control (3) 1 piece, gel ice "blocks" (18) 2
pieces.
For assembly, refer to the pictures on pages 2 and 3 and proceed as follows:
• The main unit is inserted upside down in the tank: slide it in using the side
handles (14): in case of difficulty, check that the pins (13) are not hitting the
inner edge of the tank.
• Place the main unit on a stable surface without rough spots to avoid scratching
the control panel and remove the water hose from its seat.
• Turn the tank upside down and insert the wheels into the holes on the bottom:
the 2 wheels with brake (6) must be inserted in the back and those without a
brake (7) in the front. Insert the wheels by applying pressure and check that all 4
are touching the floor.
• Make sure that the water drain plug (10) is securely fastened/screwed into its
seat; fill the tank with cool, clean water up to the maximum level indicated (word
MAX (16)) printed on the tank. Use only water, i.e., without any additives
(aromas, essences or detergents). Do not fill above the maximum level (16) or
below the minimum level (17). Move the tank very carefully when filled with
water and grip the lower edges (21). The tank holds 20 litres and provides
cooling for 55-60 hours.
• To cook the air more, insert the two ice bricks provided after leaving them in the
freezer for about 12 hours.
• Insert the main unit above the tank and inside its edges (see the pictures), taking
care to:
- handle the main unit with the 2 side handles.
- make sure that the main unit is in the correct position (control panel on top) and
that its front is aligned with the front of the tank (straight side).
- make sure that the water hose stays (15) inside the tank and without kinks.
- check that the 2 pins (13) are fully out and "engaging" the edge of the tank.
- check that the electric cord is outside of the tank and is not kinked.
- make sure the unit and tank are correctly connected.
- after placing the appliance in its more or less permanent position, check that it is
stable on the supporting surface (which, of course, must be horizontal), and lock
the rear wheels by depressing the latch in order to prevent it from moving
inadvertently.
• The air is sucked in through the two filters in the rear of the main unit: the outer
one made of synthetic material is washable and catches the larger particles (dust,
fluff, lint, etc.); it attaches using the 2 tabs on the top. The internal honeycomb
filter of natural fibres is sprayed with water by the pump and cools the air passing
through it: the water drain must be pointing downwards and must be inserted in
the rectangular slot.
• Insert the 2 AAA batteries in the remote control, respecting their polarity. Open
the rear door, insert them and then close it.
Attention: the appliance can be used only when completely and correctly
assembled.
USE
Attention: always unplug the appliance before you assemble, and insert the water
inside the tank.
This appliance is intended for home ventilation and cooling. With the "cooler"
function, the appliance adds micro-droplets of water to the air, which evaporate and
cool it: the drier the air, the more effective it is and its effectiveness decreases as
the relative humidity of the air (RH) increases. Above an RH of 75%, the cooling
effect is negligible. The honeycomb filter (20) is constantly sprayed with water and
12/41