Bimar FFFRoid VR20 Manual De Instrucciones página 13

the air picks up micro-droplets as it passes through it. The "cooler" function only
works with water in the tank between the min and max values.
These are the functions of the appliance:
- 0/1 main switch (2), turns the appliance on and off
- stand-by function (ON/OFF button) activates or stops the functions.
- normal ventilation/sleep/nature (Mode button): Normal = constant ventilation;
Sleep = ventilation increases and decreases and stops alternately; Nature =
ventilation alternately changes intensity like a breeze.
- intensity Min/Med/Max. (Speed button): adjusts the speed of the above
ventilation modes. Min = minimum speed, Med = medium speed, Max = maximum
speed.
- cooling (Cooler button): turns the cooling function on and off and, in effect, the
pump that sprays the honeycomb filter.
- timer (Timer button): turns the timer on and off (up to 8 hours with intervals of 1
hour) and stops the machine when the time elapses. If the timer is not on, the
appliance runs continuously until it is manually turned off but it turns of anyway
after running for 24 hours: after this time, just press the ON button to continue
ventilation/cooling.
- oscillation (Swing button): turns the automatic right-left oscillation on and off.
- Ionizer (Ion button): turns the ionizer function on and off, which produces a
stream of negative ions.
All the above functions are indicated by a lighted symbol on the control panel in
addition to an LED that indicates "appliance connected".
Before each use, check that the appliance is in good condition and that the power
cord is not damaged: if it is, replace it.
The functions of the fan can be turned on and off using either the button pad on
the control panel (1) or the remote control (3). The remote control must be pointed
at the control panel. Insert the plug into the outlet.
1. Turn the main switch (2) at the side to "I".
2. Attention: for the appliance to
run, the front grill must be open
(at least 45°); manually raise the
grill toward the other one, as
shown in the picture to the side:
you will hear a "click" indicating
that the appliance is in stand-by
mode.
3. To operate the appliance, press the ON/OFF button (D) on the remote control or
the control panel, the NORMAL light will turn on at the minimum FAN LOW speed;
to change the desired speed, repeatedly press the SPEED button (E) and the FAN
MIDDLE light (medium speed) and then the FAN HIGH light (maximum speed) will
turn on.
13/41