Seko OPL-ADVANTAGE Manual De Instalación página 14

OPL-ADVANTAGE – OPL system
3.2.11 Enabling or disabling drain mode:
1) Enter access code (see par. 3.2.1) ;
2) Select PUMP "5" and FORMULA "A";
3) Use to select 000 "Disable" or 001 "Enable".
4) Press ENTER;
5) The display flashes briefly indicating that enable/disable has been set.
6) Press RESET.
7) The display will show:
3.2.12 Assigning drain numbers:
The programming procedure is the following:
1) Enter access code (see par. 3.2.1) ;
2) Press MODE until pump time and delay time led are simultaneously flashing.
3) Select the formula & pump.
4) Use to select the drain number (up to a maximum of 15);
5) Press ENTER;
6) The display will be flashing briefly to indicate that the drain number is set.
7) Repeat the same operation for all formulas and pumps used.
8) Press RESET.
3.2.13 Inverting drain mode signal:
The drain solenoid valve can be set as NO (normally open) or NC (normally closed).
The programming procedure is the following:
1) Enter access code (see par. 3.2.1) ;
2) Select PUMP "6" and FORMULA "A";
3) Use to select 000 "NC" or 001 "NO"
4) Press ENTER;
5) The display will be flashing briefly to indicate that the new status has been accepted.
6) Press RESET.
OPL-ADVANTAGE
Disable
NC - Normal
code 0000136607
Enable
NO - Inverted
rev. 1.6 EN 12