Wall Mounting; Electrical Connections; Power Supply - Seko OPL-ADVANTAGE Manual De Instalación

OPL-ADVANTAGE – OPL system
2 Installation

CAUTION: Do not install the equipment close to sources of heat.
2.1

Wall mounting

•
Use the drilling template to drill the holes for the anchors.
•
It is advisable to install the system at a height of about 1.52 m (5 ft)
from the ground, and in any case in the vicinity of the product
containers.
•
Mount the brackets to the wall with the supplied ¼" anchor bolts
(Picture 1).
•
After securing the brackets in place, hang the OPL-ADVANTAGE
System from them, as shown in the picture 2.

Take care to secure the brackets to the wall correctly; Any errors in centering them
would make it difficult to mount the OPL-ADVANTAGE

If the surface of the wall is not perfectly flat, making it difficult to
mount the brackets, it is possible to secure the box directly to the
wall by drilling through the breaking lines inside each box and
mount the box to the wall using the supplied ¼" anchor bolts. To
maintain the IP protection degree, it is advisable to apply silicone to
the screws inside the box.
2.2

Electrical connections


CAUTION: Always disconnect the OPL-ADVANTAGE System and the laundry machine
from the power supply before making any connections.

All the wiring connections to the OPL-ADVANTAGE System should be checked using a
multimeter. Incorrect connections could seriously damage the unit and invalidate the
warranty. Refer to the wiring diagram contained in this manual for all signaling and power-
supply connections.
2.2.1

Power supply

Insert the cable through the PG7 conduit on the left of pump unit after
connects the cable on the circuit board as shows the picture 3:
With the OPL ADVANTAGE, there is no need to select a voltage for
power supply. The circuit board, (located on the left side when facing
the cabinet) will automatically detect and accept any voltage from
100VAC to 240VAC. This is known as SEKO's AUTOMATIC
SWITCHING feature.
OPL-ADVANTAGE code 0000136607
Picture 1
Picture 2
Picture 3
rev. 1.6 EN 5