Material Required For Installation - Seko OPL-ADVANTAGE Manual De Instalación

OPL-ADVANTAGE – OPL system
1.5 Warnings

Read this manual carefully before proceeding with the installation and starting up the
OPL ADVANTAGE system.

The dosing unit should be connected to the power supply by means of a single-pole
breaker having an opening distance equal to or greater than 3 mm (⅛").

Check the model of the equipment purchased for the reference information contained in
this manual for installing, setting and programming it.

For all connections, refer to the diagram of the control circuit contained in this manual.

CAUTION: Always follow the appropriate safety procedures, including the use of
suitable
means for protecting the eyes, face, hands and clothing.

CAUTION: Always disconnect the equipment from the power supply before carrying out
the installation or any maintenance work on it.

Seko is working constantly to improve all its products and reserves the right to make
changes at any time without prior notice.

Failure to comply with the instructions contained in this manual could cause damage to
property or personal injury, prejudice proper functioning of the equipment or damage it.
1.6

Material required for installation

•
Electrical cable for connections.
•
Different tie-wraps to secure tubing and cables.
•
PVC hose 11 mm (7/16") OD x 8 mm (5/16") ID (for pick-up and delivery)

Other installation material is also available (see chapter 5, Maintenance and Accessories).
OPL-ADVANTAGE code 0000136607 rev. 1.6 EN 4