Motorized Mount - Agatec A510S Manual De Operación

2.7 Motorized mount

3
7
7
5
1
6. Moves laser manually on mount
7. Holes for attaching mount to wall
8. Adjustable support for wall or ground stability
9. Screw to adjust support
10. Index notches for alignment
2.7.1 Motorized mount
The motorized mount can be used to move the laser up or down on
a ceiling grid. It also can be used when installing walls and partitions,
to move the laser back and forth for vertical alignment. To move the
mount manually, use (6).
Caution:
Be careful when you are in wall mount mode not to press + or –
keys unless you intend to move the laser.
Maximum movement
When the beam is at 0 on the adjustable plate, the laser can be
raised a maximum of 2" (50 mm) and lowered 2.25" (60 mm).
Wait until self-leveled
While the laser is moving on the mount, it does not self-level and
the beam continues to rotate. After moving the laser, wait a few
seconds in case it needs to self-level. Check that it's still on the point
or level desired, and make adjustments if needed.
Automatic exit from mode
If you have not activated the wall mount for five minutes, the laser
will automatically exit from wall mount mode and return to the pre-
vious mode (3 LEDs will be off and a beep will sound).
10
2
6
4
1
1. Attachment clamps for laser and mount
2. Clamp for ceiling grid
3. Adjustable plate
4. 5/8-11 tripod mount (vertical setup)
5. Release for adjustable plate
Functions not available
H.I. Alert, setting slope in manual mode, or moving the scan or
10
plumb point are not available in wall mount mode. Exit wall mount
9
mode to use these functions.
Detaching the mount
8
Screw both knobs (1) all the way out to detach the mount from the laser.
Troubleshooting
If the laser does not move on the mount, check that the knobs (1)
are tight enough to make the power contact for the motor. The
mount can also be detached to check that the contacts where the
laser and mount are fastened are clean.
Setup:
1. Check that the laser and mount are connected securely. The
knobs (1) should be turned fairly tight to make contact for the
motor, although do not overtighten. Check that the safety clip
is well engaged.
2. Flip down the support plate (8).
3. Release the clamp (2) on top of the adjustable plate (3).
4. Lock the clamp against the ceiling grid. The grid should not
exceed 1/8" (3mm) thickness.
5. If the foot on the support plate is not touching the wall, use
the screw (9) to adjust.
To move the laser up or down with the remote control:
1. Turn on the laser and wait for it to self-level. The head must
be rotating before you can enter wall mount mode.
2. Press the scanning key and hold it for several seconds until
you hear 4 beeps. This will put the laser in "wall mount mode".
All three LEDs will blink.
3. Press the + key to move the laser up; press – to move the
laser down. Holding the key will result in fast movement; short
clicks will move the laser more precisely.
If you don't raise or lower the wall mount for 5 minutes, the
laser will go back to its previous mode. You'll hear a 4-second beep.
1. Check that the laser and mount are connected securely. The
knobs (1) should be turned fairly tight to make contact for the
motor, although do not overtighten.
2.7.2 Using the laser with wall mount
on a ceiling grid
2.7.3 Using the motorized mount
and laser on the floor
11