Environmental Protection - Worx WG163E Manual Del Usuario

Checking the battery condition
(Only for WG163E.1, WG163E.2)
Operation
Safety ON/OFF Switch
WARNING! The cutting
head continues to rotate
after the trimmer has been
switched off; wait until it has
completely stopped then lay down
the tool.
Trimming
- Adjusting the Shaft
WARNING! Make Sure the
ON/OFF Switch is Locked
Off to Prevent Accidental Starting.
- Adjusting the Trimmer Head
- Adjusting the Auxiliary handle
- Trimming
- Using the Flower Guard
Edging
- Changing the tool into the
Edging mode
- Edging
Command feeding the line
14
- Note: Press as needed.
Manually feeding the line
Replacing the trimmer Spool
Manually winding the line
WORKING HINTS
1. AUTOMATIC LINE FEED SYSTEM
When initially switching on the trimmer, a small
length of line is fed out.
A 'clattering' noise will be heard when the lines hit
the Line Cutter. DO NOT BE ALARMED. This is quite
normal. After about 5 seconds the line will be cut to
the correct length and the noise will reduce as the
motor gains full speed.
If the noise of the line being cut can't be heard, more
line will need to be fed out.
To feed more line, it is first necessary to allow the
trimmer to stop completely; it must come to a
complete rest, then restart, allowing the motor to
reach full speed.
Repeat above until you hear the line hitting against
the Line Cutter.
2-in-1 Grass Trimmer/Edger
2.
See Fig. D3
Your grass trimmer is equipped with a Command
Feed System. Just press the button while the
machine is running, new line will feed out and then
stop when you hear the 'clattering' noise of the
new line being cut. The motor stops briefly when
the Command Feed button is pressed, and restarts
See Fig. E when released. This process enables the machine to
automatically feed out new line.
3. MANUALLY FEEDING THE LINE (See Fig. M)
Press and release manual line feed button (14), whilst
gently pull out the lines until the lines reaches the
line cutter.
If the line extends past the line cutter, too much line
has been fed out.
See Fig. F
If too much line is fed out, remove the cutting head
cover and rotate the spool anti-clockwise until the
line is at the desired length.
See Fig. G1, G2
See Fig. H
MAINTENANCE
See Fig. I1
After use, disconnect the battery from the tool and
See Fig. I2
check for damage.
Your power tool requires no additional lubrication
or maintenance. There are no user serviceable parts
in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with a
See Fig. J1, J2
dry cloth. Always store your power tool in a dry room
temperature location. Keep the motor ventilation
See Fig. K
slots clean. Keep all working controls free of dust.
See Fig. L
ENVIRONMENTAL
See Fig. M
PROTECTION
See Fig. N1, N2,
N3
See Fig. O1, O2,
O3, O4
or retailer for recycling advice.
(See Fig. L)
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
EN