Technical Data; Noise Data; Vibration Information - Worx WG163E Manual Del Usuario

1. LOCK OFF BUTTON
2. REAR HANDLE
3. ON/OFF SWITCH
4. BATTERY PACK *
5. HANDLE UNLOCK BUTTON
6. UPPER SHAFT
7. LOCKING COLLAR
8. LOWER SHAFT
9. SAFETY GUARD
10. FLOWER GUARD
11. AUXILIARY HANDLE
12. COMMAND FEED BUTTON
13. EDGER WHEEL
14. LINE FEED BUTTON
15. LINE CUTTER
* Not all the accessories illustrated or
described are included in standard delivery.

TECHNICAL DATA

Type WG163E WG163E.1 WG163E.2 WG163E.9
(1-designation of machinery, representative of
Battery- powered Lawn Trimmer)
WG163E
WG163E.1
Voltage
No load
speed
Cutting
diameter
Line
diameter
Charging
5hr
time
Machine
2.4kg
weight
**Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
2-in-1 Grass Trimmer/Edger
WG163E.2 WG163E.9
20V MAX**
7600/min
30cm
1.65mm
1 hr /
2kg

NOISE DATA

A weighted sound pressure
K
pA
A weighted sound power
Wear ear protection

VIBRATION INFORMATION

Vibration emission value
Uncertainty
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING! The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use the correct accessory for the tool and ensuring
it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING! To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimize your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
L = 74dB(A)
pA
3.0dB(A)
L = 90dB(A)
wA
a <1.8m/s²
h
K = 1.5m/s²
9
EN