Power Adapter And Cable With Charging Clip; Preparing Transmitter (Collar); Charging The Transmitter; Checking Battery Charge Status - Dog trace GPS X30 Manual Del Usuario

5.3 Power adapter and cable with charging clip

3
6

6.1 Charging the transmitter

GPS transmitter includes Li-Pol battery, which must
be charged before the first use.
1. Remove dirt from charging contacts. Connect the
charging clip to the transmitter (see figure).
2. Connect cable to the power adapter, which is then
plugged into the mains.
3. Orange indicator light is illuminated.
4. Charging takes approximately 3 hours.
5. Orange light goes off when charging is finished.
WARNING: Charge the battery at temperatures between 0 °C to 40 °C. Use only
the original power adapter supplied by the manufacturer for charging as using
different one may lead to irreparable battery damage.

6.2 Checking battery charge status

Flashing indicator lights located on the top of the transmitter (see Paragraph: 5.1
Equipment Description – Transmitter) or the battery symbol on the receiver (handset)
display are used to check the battery charge status.
Charge status
100%
70%
40%
10%

6.3 Turning on/off

Magnetic switching system, activated by applying magnet, is used for switching the
transmitter on/off. The magnet is fitted in the receiver where the red target is located
(half-round red dot located on the bottom of the receiver).
36

PREPARING TRANSMITTER (COLLAR)

Receiver Transmitter
Green indicator light
—
Simultaneously green and red indicator lights
Red indicator light
1
1. Power adapter
2. USB cable
3. Charging clip
2