Pairing - Encoding Transmitter (Collar) With Receiver (Handset); Pairing - Encoding Another Receiver (Handset) With Your Receiver - Dog trace GPS X30 Manual Del Usuario

7.5 Pairing – encoding transmitter (collar) with receiver (handset)
1. Turn on the receiver and transmitter you wish to pair together – switch other
devices off.
2. Hold the CODE push button on the receiver for 2 seconds.
3. Select the position to which you wish to pair the transmitter (collar) by using
arrows. If the position is empty (there is no paired transmitter, receiver or saved
waypoint), the
4. Hold the CODE push button again for 2 seconds.
5. Move the transmitter close to the receiver with the RF aerials parallel to each
other.
6. After pairing, the
lit on the display (according to the selected position to which the transmitter is
paired).
7. If you wish to pair another transmitter, repeat the procedure from Point 3.
8. To exit the coding mode press
NOTE: To delete one of the paired transmitters (collars), receivers or waypoints
from the receiver's memory, carry out pairing without the transmitter turned on.
After approximately 20 seconds, the
position.
NOTE: The receiver X30 is possible to pair with X20 / X20+ transmitters (collars). It
is not possible to send training commands to these collars. Some other functions
are limited.
7.6 Pairing – encoding another receiver (hand set) with your receiver
DOG GPS X30 enables pairing of other dog handlers' receivers with your receiver
and then track their position. Updating the position of other dog handlers in your
receiver takes place every 60 seconds.
Turn on another receiver to transmit its position before pairing your receiver with
this receiver commences.
1. Long press the MENU push button on the receiver you wish to track.
2. Select
3. Select
and by repeatedly pressing
Now, you may start pairing this receiver with yours.
1. Turn on your receiver and the second receiver you wish to track – transmitters
(collars) in your vicinity must be turned off.
2. Hold the CODE push button on both receivers for 2 seconds.
3. On your receiver, select the position to which you wish to pair the second
transmitter (collar) using
there is no paired transmitter, receiver or saved waypoint), the
message is shown on the display.
40
message is shown on the display.
message is displayed and
.
arrows and long press MENU again.
by using /
return to the main screen.
/ arrows. If the position is empty (at given position
message appears at the given
/
to is