Car Mode - Dog trace GPS X30 Manual Del Usuario

Setting the delay–
Setting the delay for Mode 0, 1, 2, 5 and 6 – the indication is activated when the
dog stays in the given state (motion/standstill) for the set time. The status indication
delay is also dependent on the set updating frequency (Paragraph 6.4, Page 37).
Updating
frequency [s]
Time
Indication delay [s]
The times given in the table are indicative.
Setting the radius –
Setting the virtual circle radius only relates to hunting wild boars. If the dog stays
within this circle for a certain time, the receiver asses that the dog is in the wild pig
vicinity. The circle radius may be set between 5 and 60 m.
Setting the time –
Setting the time only relates to the hunting wild boars mode. The indication is
activated if the dog stays within the virtual circle for a certain time. The time may be
set between 30 and 120 seconds.
NOTE: The activated sound and vibration function can be deactivate while using
the BEEPER function by pressing the key
only for the currently selected transmitter, that is currently being displayed in the
main navigation menu. After dog's status is changed - movement / standing by,
the indicator is activated again.

8.7 CAR mode

Car bodywork and electronics may affect the digital compass function in the receiver
– tracked dog direction may not be displayed correctly. When the CAR mode is
enabled, the tracked dog direction will not be determined from the digital compass,
but from the change in the GPS receiver's position.
Turning the car mode on/off:
1. Press and hold the MENU button and select with
2. To enable the mode select
3. For the correct operation, it is necessary to keep the RF receiver in the direction of
travel and at the same time keep moving (speed higher than 1 m/s). If the receiver
is not moving, the arrow will start blinking and keep pointing the last stored
direction.
48
3
1 2 3 4
7 10 13 16
, to disable the mode select
6
1 2 3 4
10 16 22 28
. The indication will be deactivated
/ the
9
1 2 3 4
11 20 29 38
setting.
.