Charger Operation Instructions; 6.1 Charger Setup; Charger Operation; Replacement Parts - Sunoptic Surgical SSL-5500 Manual De Uso

6.

CHARGER OPERATION INSTRUCTIONS

6.1 Charger Setup

•
The charger should only be powered by the AC adaptor supplied with the unit.
•
Check the AC adaptor and install the appropriate plug assembly that fits the supply
mains outlet.
•
Depending on the AC adaptor model, change the plug assembly by either sliding
down the retaining clip and pulling out the plug assembly or by pushing in the retaining
clip and sliding out the plug assembly. Insert the correct plug assembly by performing
the reverse operation.
•
Plug the AC adaptor into mains power
•
Plug the output of the AC adaptor into the input jack on the rear of the battery charger
noted in figure 4.
•
When power is correctly applied, the status indicator will be GREEN.
6.2 Battery Charger Operation
•
The operation of the charger is automatic.
•
Simply place the battery pack into the charger pocket as displayed in figure 4. Ensure
that the two gold contacts on the battery pack are placed face down into the pocket.
•
The status indicator will change to RED to indicate that the charger is charging the
battery.
•
When the battery is fully charged, the status indicator will change to GREEN.
•
The status indicator will start flashing in the event that the charger is operating outside
of its temperature range.
NOTE: Ensure that the battery pack is fully inserted into the charger by pushing down on the
battery pack when inserting into the charger. If the battery pack is not fully inserted,
it will not charge.
7.

REPLACEMENT PARTS

For replacement parts, additional, or optional equipment please call Customer Service
(877)-677-2832 (+1-904-737-7611 International).
LIT-237 Sunoptic Surgical
Rev. C
Figure 4. Battery Charger Diagram
®
Page 7 of 71
1. Status Indicator
2. AC Adaptor Connector
(English)