Solo 117 Manual Del Usario página 26

Repeat until the engine „pops" or attempts
to start.
7. Immediately move choke (4)
to run position! Pull starter grip.
8. Once the engine runs,(1), briefly apply full
throttle (2) and release to return engine RPM
to idle speed.
Start up with warm engine/start up
after brief cut-off
Leave choke open and start engine.
If engine does not start, activate
half-throttle (2). Repeat starting.
Starting and shutting off engine,
22
bicycle design
Preparing to start
Caution! Lay brushcutter on ground,
free of any obstructions. Assume a
steady position, hold unit securely,
and take care that the brushcutter does not
touch any objects nor the ground. Do not stand
or kneel on the shaft tube since the shaft or tube
may become damaged.
Grasp the multi-function grip, pull throttle lever
(1), move switch (2) to start position, release
throttle lever.
This is the half-throttle position.
Cold start / first start
Close choke (4) with choke lever.
Push Primer (5) several times until gasoline is
visible in the bulb and resistance is felt.
Hold the unit on the flange housing with the
left hand. With the right hand, slowly pull out
with the starter grip (6) until the first resistance
is felt, and then quickly and forcefully pull
through until the engine starts.
Immediately put choke (4) into the
run position! „Open choke lever"
and continue starting.
Once the engine runs, activate throttle lever (1)
briefly apply full throttle (2) and release to
return engine R.P.M. to idle speed.
Caution! If the engine does not start
in spite of several starting attempts,
it may be flooded.
Flooding may be corrected by removing and
drying the spark plug.
Move the switch to „stop" and the throttle lever
to full throttle. Pull the starter grip (with spark
plug removed) several times in order to clear
cylinder. Replace spark plug.
Repeat starting procedure.
Start up with warm engine/start up after
brief cut-off.
Leave choke in open position
and start engine. If engine does
not start, activate half throttle
lock (2). Repeat start.
22
Shutting off engine
Move switch (2, illustration 22) to stop position.
Slide stop switch (3, illustration 20) to STOP
position until the engine stops.
Caution! Cutter may briefly
continue to run!
• Prior to operating the brushcutter and prior
to each start, check the brushcutter's condition
(gasoline supply, stop switch, protective shield,
carrying strap, cutters and gasoline leaks).
• Prior to starting the engine and during all jobs,
the operator needs to be positioned in a safe
manner.
• The throttle should return to the idle position
by itself. The cutting unit has to be firmly
attached and be in good operating condition.
The idle run has to function trouble-free, and
during idle run the cutting attachments should
not turn!
• When starting the brushcutter, move at least
3 meters (10 feet) away from the fueling area.
26