Fuel Recommendations; Engine Oil Level Check; Engine Oil Change - LCT PGM45005 Manual De Empleo

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Servicing Your Engine

FUEL RECOMMENDATIONS

Use unleaded gasoline with a pump octane rating of 86 or higher. These engines
operate best on unleaded gasoline.
Do NOT use stale or contaminated gasoline or an oil/gasoline mixture. Avoid getting dirt
or water in the fuel tank. Use only proper fuel containers that are properly marked.
Maximum recommended ethanol content: 10%.
This is not compatible with E15.

ENGINE OIL LEVEL CHECK

Check the engine oil level with the engine stopped and with the engine
in a level position.
1. Remove either side mounted filler cap dipstick or high oil fill dipstick (if equipped)
and wipe it clean.
2. Insert the dipstick into the filler neck and turn clockwise until fully seated. Then
remove the dipstick by turning it counter-clockwise. Check the oil level shown on
the dipstick.
3. If the oil level is low, fill to the edge of the oil filler hole with the recommended oil.
4. Securely screw in the filler cap/dipstick. Running the engine with a low oil level can
cause engine damage. Always check the engine oil before start up.

ENGINE OIL CHANGE

Drain the used oil while the engine is warm. Warm oil drains quickly and completely.
Avoid contact with hot oil.
1. Place a suitable container below the engine to catch the used oil then remove
the filler cap/dipstick and the drain plug.
CONTINUED
Fill if oil is
below letter
"L" on the
filler cap
Liquid Combustion Technology, LLC Engines Manual 14
Optional
Fill if oil
is below
"Add"
on the
dipstick
continued on next page

Publicidad

Tabla de contenido
loading

Tabla de contenido